Polyurethane Foams

2 lb. Concrete lifting/Void filling Polyurethane Foam

High density, plural component polyurethane foam designed for light duty concrete lifting, void filling and soil stabilization. Great for sidewalks and patios.

4 lb. Concrete lifting/Void filling Polyurethane Foam

High density, plural component, polyurethane foam designed for concrete lifting and void filling applications. This system is hydrophobic/hydro-Insensitive making it ideal for applications where water may be present under or around a concrete slab. This system offers excellent compressive and tensile strength values (based on ASTM test methods) and is highly resistant to chemicals and solvents.

4 lb. Slow Reacting Concrete lifting/Void filling Polyurethane Foam

High density, plural component, polyurethane foam designed for concrete lifting and void filling applications that require a slow reactivity (cream time 15 seconds and rise time up 60 seconds) with excellent below slab flow characteristics. This system is hydrophobic making it ideal for applications where water may be present under or around a concrete slab. This system offers excellent compression and tensile strength values (based on ASTM test methods) and is highly resistant to chemicals and solvents.

4 lb. Slow Reacting Micro-lifting/Void filling Polyurethane Foam

High Density, plural component, polyurethane foam designed for concrete slab undersealing and void filling applications. With an extended reactivity profile (cream time 80 seconds and rise time up to 380 seconds), it flows and reacts with good undersealing characteristics and minimal lift. This system has excellent compressive and tensile strengths (based on ASTM test methods) and is highly resistant to chemicals and solvents.

6 lb. High Compressive Strength Concrete lifting/Void filling Polyurethane Foam

High density, plural component, polyurethane foam for concrete lifting. When higher compressive strength and tensile strength are required, this system is ideally suited for the application.

Spray-in Substitute Light Weight Back Fill Polyurethane Foam

Two component co-blown, polyurethane foam designed and used for constructing pipeline trench breakers, pipe pads and or pillows. This system was specifically formulated for great lift thicknesses without scorching or splitting during field applications. This system will process at 2.0 to 2.2 lbs per ft3 depending on thickness. It has been tested per ASTM test methods at 27 psi compression strength and a closed cell content >95%. 24-023 is an excellent choice for filling large open pits, voids, trenches and areas that require a lightweight back fill substitute to soil, sand or stone.

Sub Grade Substitute Light Weight Back Fill Polyurethane Foam

Plural component, polyurethane foam designed for uses in and around areas that require sub-grade cavity and substitute back fill applications. This system is formulated with low exothermic heat generation for spray and injection applications. Typical physical properties consist of 55 psi compression strength, closed cell content >95%, water absorption less or equal than 0.03 lbs/ft2. All test values are per ASTM approved test methods.

Single Component Soil Stabilization & Water Cutoff Polyurethane Grout

Single component, low viscosity (100 cps), polyurethane grout ideally suited for soil stabilization and water cutoff applications. Compressive strength exceeds 1,000 PSI.

 

Contact us to speak with a member from our team about your next project….. (952) 818-POLY